This guide explains how to safely remove the wheels from your petrol lawnmower. The exact method may vary depending on your model, so please follow the section that matches your machine.

Table of Contents

  1. Front Wheels
  2. Rear Wheels (XSZ41D, XSZ51C and Similar)
  3. Rear Wheels (XSZ48A, XSZ53C and Similar)

Front Wheels

Step 1 – Remove the Wheel Trim / Hub Cap

Start by carefully removing the wheel trim (hub cap).

  • Use a flat-head screwdriver or similar tool
  • Gently lever the trim off
  • If it is tight, work around the edge in multiple positions until it releases


Step 2 – Remove the Fixings

Once the hub cap is removed, you will see the retaining components.

Using a wrench or spanner:

  • Remove the nut (47)
  • Remove the washer (48)

The wheel should now come free from the axle.

Step 3 – Remove the Wheel

Carefully slide the wheel off the axle.

Be mindful of the internal components, including:

  • Bearings (49)

These may remain in place or come away with the wheel.

Step 4 – Reassembly

To refit the wheel, repeat the process in reverse order, ensuring all components are correctly seated.

Rear Wheels (XSZ41D, XSZ51C and Similar Models)

Step 1 – Remove the Wheel Trim

Remove the hub cap as described in the front wheel section.


Step 2 – Remove the Wheel Fixings

Using a spanner:

  • Remove the nut (47)
  • Remove the washer (48)

Step 3 – Remove the Wheel

Take off the wheel carefully, ensuring you do not lose or damage:

  • Bearings (49)
  • Cog (58)
  • Dust cover (51)

Step 4 – Remove the Circlip

Using suitable circlip or long-nose pliers:

  • Remove the circlip (52)

This releases the drive cog (58) from the axle.

Step 5 – Reassembly

Refit all components in reverse order, ensuring:

  • The cog is correctly seated
  • The circlip is fully secured
  • The wheel rotates freely after assembly

Rear Wheels (XSZ48A, XSZ53C and Similar Models)

Step 1 – Remove the Wheel Trim

Remove the hub cap as described previously.


 

Step 2 – Remove the Wheel Fixings

Using a spanner:

  • Remove the nut (30)
  • Remove the washer (42)

Step 3 – Remove the Wheel

Carefully remove the wheel, taking care not to lose the bearings (44).

Step 4 – Remove the Cog Gear Assembly

To remove the cog gear (46) and dust cover (48):

  • Unscrew the three screws (47)
  • Carefully remove the assembly from the wheel hub

Step 5 – Reassembly

Reassemble the wheel in reverse order, ensuring all fixings are secure and the wheel spins freely once refitted.