Quick answer
If the on/off switch on your robot mower has become damaged, a replacement switch can be fitted by following the steps below.
Make sure you install the switch correctly and do not turn it past the “I” position, as this may damage the new switch.
Before you begin
Before installing the replacement switch:
- Make sure you have received the correct replacement switch for your robot mower
- Switch off the mower
- Disconnect the charging station power supply
- Have a suitable screwdriver available
- Check the replacement switch is not damaged before installation
If the switch on the back of your robot mower has broken, contact our service team to request a replacement part.
Steps
1. Remove the existing switch
- Locate the switch housing on the rear of the robot mower.
- Remove the screw securing the switch in place.
- Carefully remove the damaged switch.
2. Install the replacement switch
- Insert the new switch into the switch housing.
- Turn the switch to the “I” position.
- Check that the robot mower beeps and the control panel lights turn on.
The replacement switch is now installed correctly.
Important information
Do not turn the switch beyond the “I” position.
Turning the switch further than this may damage the switch and cause it to fail again.
Frequently Asked Questions
Where is the robot mower on/off switch located?
The on/off switch is located on the rear of the robot mower.
What should I do if my robot mower switch is broken?
Contact our service team to request a replacement switch.
How do I know if the new switch has been installed correctly?
When the switch is turned to the “I” position, the robot mower should beep and the control panel lights should turn on.
Can I turn the switch past the “I” position?
No. Do not force the switch beyond the “I” position, as this can damage the replacement switch.
If you are still experiencing issues after installing the replacement switch, contact our support team through live chat for further assistance.